Reedin Flight Attendant Foil Set 2022/23
New design features have been introduced to increase turning, glide, and most of all predictability. Increased predictability helps you advance your riding from learning on flat water through to massive jumps and fully ventilated turns.
The profile, outline, twist and taper have been designed in order to allow for greater stability & efficiency, easy take off at low speed and superior manoeuvrability all while allowing for impressive performance over a very wide range of speeds.
The curved wingtips keep ventilation from moving up when getting close to the water surface, making the FlightAttendant extremely forgiving.
The front wing and rear stabiliser perfectly complement each other which allows for a short fuselage that results in a foil that is amazingly stable and very easy to manoeuvre and will amaze you when effortlessly pumping from one wave to the next.
Reedins design goals for the new FlightAttendant
Aspect: The FlightAttendant foil set has a higher aspect ratio to increase the glide/turn ratio. They are also flatter with a less aggressive overall curvature to increase speed and ventilation resistance.
Profile: The profile was chosen based on a few factors- ease of takeoff, speed range, and ventilation resistance. The airfoil on the flight attendant has a very low stall speed and high stall angle. This helps get you on foil easily with a wide range of boards & wing combinations, skill level and conditions. It also helps when landing jumps and pivoting in the pocket.
Front Wings: The wingtips have been slightly flattened and straightened this generation. The airfoil gain in ventilation resistance lets us run less curvature in the tip. The front wings come in 5 sizes ranging from the 780, 980, 1280, 1480 to the 1880.
The 780 and the 980 can both be used for kitefoiling.
For dimensions see the Tech Dimensions Tab
Rear Wings/Stabilisers: There are three sizes of rear stabilisers. The 33cm (Small) stabiliser is matched with the 780, 980 set up. The 38cm (Medium) stabiliser is matched with the 1280 and the 1480 set up and the 46cm (Large) stabiliser is matched with the 1880 set up. The rear stabilisers can be adjusted by one degree by sliding the stabiliser forward or backwards on the fuselage.
Masts: The mast range comes in two options, Aluminium (Alloy) in 75cm or 85cm lengths and 85cm length in the High Modulus Carbon mast.
Fuselage: The new fuselage has been revised to reduce weight and drag while increasing modularity. The mast now uses a conical box-style connection for absolute rigidity between mast and fuselage. The tail section has a reduced cross section and is slimmer and the front wing connection is hollowed out to save weight.
For Tech Specs: See Tech Specs Tab
For wing and stabiliser dimensions see the Tech Dimensions Tab

































Reviews
There are no reviews yet.